Cutting Tool Reconditioning

Cutting tool reconditioning can mean the difference between that costly carbide bit being fully a bargain or just a very expensive little bit of metal. Cutting tool reconditioning is different as resharpening. Whenever you resharpen a cutting tool, it won't become the same bit you bought. It'll still cut and could even do the job you are interested for, but following a cutting tool is reconditioned, it can be like a new tool again and can have all of the characteristics of a brand new tool. Once you resharpen a cutting tool, the edge and point geometry won't be exactly like if it is new, but cutting tool reconditioning will make certain that everything concerning the cutting tool is equally as when it was new.

When having your cutting tool reconditioning done, be sure to have these four points covered. Your contractor doing the reconditioning should make sure to identify the drill point geometry and coating (if there's one) before doing the other work involved. This may allow him to set up his machinery properly to provide you with back a reconditioned as new cutting tool. In some cases, the tool as originally purchased may have been as close to ideal as you could actually find it. During the inspection process, you can discuss this together with your reconditioning contractor and if he's good at his job, he should have the ability to adjust the drill point geometries to raised suit your needs.

The next phase in the cutting tool reconditioning is always to regrind new surface on the cutting areas. This step is vital to making the tool like new again or if needed, more suited to your needs compared to the original. This step is way better done today by computer numerically controlled grinding machines then your old design of controlling it by hand. Computer numerically controlled grinders can be more precise than hand eye coordination is. This is how your cutting tool may come back like new again.

The next phase in cutting tool reconditioning would be to chamfer or across the edges sufficient to prevent splitting and chipping when you use the cutting tool. If the edge is too sharp. The first time you use them, they could split or chip, thus ruining the cutting tool for further use. It must be sharp enough to complete the work required, although not sharp enough to become brittle. This is vital in the cutting tool reconditioning to produce it such as for instance a new tool again.

The final steps to take are the quality inspection and recoating if needed. Quality inspection should not be completed with the naked eye. At the minimum cutting tools, a microscope should be used to examine the cutting surfaces and locate any imperfections. Good cutting tool reconditioning requires this inspection so any defects can be corrected ahead of the recoating process. After the quality inspection, the final step is to reapply any coating that is needed to really make the cutting tool operate at maximum efficiency. When this task of the cutting tool reconditioning is finished, you will have a like new cutting tool once again.

About This Author

fareedy shakir Joined: April 22nd, 2019