Some Suggestions For A Beginner On Pallet Forks

Choosing pallet forks for your specific purpose from a range of options available in the market can be a bit difficult for a beginner. You could spend more money than you had to if you do not properly research beforehand. It will be wrong to think that all the pallet forks for tractor are the same. In this article, we’ll try to help you find the right forks for your needs and bring down the confusion you experience while shopping.

Focus on the Size

There is no dearth of pallet forks in the market. There are plethora of them with different options available to suit your specific requirement. If you’re going to be transporting palleted loads mostly, make sure you keep in mind your pallet dimensions. A normal pallet is 48 in by 40 in. There are brick guards in the market that have full-width guards for loads like bricks, there are types of guards, known as walk-through, that allow for better entering and exiting a skid steer a lot more simpler. You can get options that do not feature brick guards.

In pallet fork setup, you’ve got to have an idea about the load and lift capacity. Light duty pallet forks are those forks which are made for being employed in small skid steers and compact utility tractors. These forks may have restrictions on fork line spacing that makes it unusable for certain applications. They will have rate capacities of about 2,500 lbs. These forks are used in smaller skid steers.

For bigger skid steers and tractors, heavy duty pallet forks are more suitable. These forks are perfect for telehandlers. They, on the other hands, have rate capacities of about 10,000 lbs. This allows them to transport loads which are quite heavy. These are rather expensive and not required unless your requirements specifically call for heavy duty forks.

Operation Tips

You should place forks close to the ground during transportation for improved visibility and to obtain a lower center of gravity. Give a proper reading to the operator’s manuals for both the pallet forks and vehicle and carry out timely maintenance mentioned in the manual. To avoid the unnecessary movement of the load, spread it equally between the tines.

You need not worry if your do not have round bale spear for front end loader as pallet forks will be enough for situations where you’re moving square bails round.

Author’s Bio: The author is a blogger. This article is about pallet forks.

About This Author

Jamesonmaria Joined: January 28th, 2019