How to fix Canon Printer Error Code B200

How to fix Canon Printer Error Code B200

When you need to print something significant, it's frustrating and an error code pops up. B200, which can signify a potentially catastrophic device error, is one of the most dreaded Canon printer errors. Do not immediately junk it, though. Printers are expensive, and before you shop for a new printer, there are a few methods you can try to fix an error.

Causes of the Canon Printer Error Code B200

The B200 error at its most basic level indicates a faulty print head. A print head is a component that distributes the ink onto the paper from the cartridges, which means it is one of the most important aspects of the printer as a whole. Printing heads, particularly on cheaper printers, are known to be problematic.

FIXED - Canon Printer Error Code B200

To attempt to fix a defective print head and remove the B200 error, there are several things you can do. Already when you replace the entire device, try some of the proposals below.

1. Make the printer reset. Disconnect it and leave for at least 30 minutes to disconnect it. A good, long reset enables the printer to cool down and restore everything to its proper position before turning the device back on.
2. Remove any blockages. There is a chance that something is disrupting the connexion to the head of the printer. Open the door of the printer and disconnect the print head carefully, then lift it out of the appliance. Reset it and see if the problem is fixed by that. Reseat it and see if that fixes the issue.
3. Typically, there is a lever on the head of the printer. In order to remove the printer head, press the lever.
4. Clean the printer head. Use maintenance options for the device to run its cleaning cycle. This is particularly beneficial if the head of the printer is clogged.
5. Clean the printing head manually. Use either pure alcohol or a non-oil-based cleaner on the gold contacts of the printed head. Rub the cleaner onto the contacts using a microfiber cloth, then let it dry completely before reconnecting.
6. The head of the print is very fragile, so handle it carefully.
7. Delete the old ink. There may be toughened ink trapped within the print head. Run it under hot tap water until the water comes out wipe. With a paper towel, dab it dry, then reinsert the head into the printer.
8. Re-install drivers for printers. Locate your device on the official Canon support page and follow the driver update directions.
9. Try a new cartridge with ink. The B200 error is rarely triggered by defective cartridges, but it can happen. Concerning your specific device, refer to the user manual for this process.
10. If none of the above methods works, it is likely that the B200 error is accurate. It's time for a new printer to shop for.

About This Author

Robert john Joined: February 3rd, 2020